An oven that will not come up to heat is one of the more disruptive faults in a kitchen, especially in a Evergreen home during a holiday week when the oven is the center of the meal. The good news is that oven heating faults are usually traceable to a small number of parts. A gas oven relies on a bake igniter that glows hot enough to open the gas valve; when it weakens, the valve never opens and the oven stays cold. An electric oven relies on a bake or broil element that either works or does not. Both rely on a temperature sensor to tell the control how hot the cavity is, and a drifting sensor makes an otherwise healthy oven run cool.
Most Common Causes
- Weak or failed bake igniter: on a gas oven, an igniter that no longer glows hot enough will not open the safety gas valve.
- Broken heating element: on an electric oven, a cracked or burned bake element stops producing heat.
- Failed temperature sensor: a drifting sensor makes the oven run cool, slow, or shut off early.
- Control board fault: a bad relay or board can stop the heat call entirely.
- Door or latch fault: a door that reads as open, or a stuck lock after self-clean, can block heating.
Notes by Brand
Where the fault usually sits depends on the brand:
- Wolf: dual-fuel ovens are electric, so a bake element or sensor is the usual cause, and E-series faults on the display help narrow it.
- Viking and La Cornue: gas ovens are diagnosed by symptom, and a weak bake igniter that no longer opens the valve is the classic no-heat cause.
- Thermador, Bosch and Monogram: these usually display an F-code for a sensor or control fault that points to the failed part before we open anything.
- Miele and KitchenAid: electric ovens flag sensor and element faults, and a stuck door lock after a self-clean cycle is a frequent culprit.
| What You See | Likely Cause | What the Fix Involves |
|---|---|---|
| Gas oven stays cold | Weak or failed bake igniter | Replace the igniter |
| Electric oven no heat | Broken bake element | Replace the element |
| Heats but runs cool or slow | Drifting temperature sensor | Test and replace the sensor, recalibrate |
| No heat after self-clean | Blown thermal fuse or stuck lock | Replace the fuse, free the latch |
Safe Checks Before You Book
Confirm the oven is getting power and, on an electric model, that the breaker has not tripped. Make sure the door closes fully so the switch reads it as shut. If the oven failed right after a self-clean cycle, a thermal fuse may have blown, which is a common and fixable cause. Do not run a self-clean cycle to try to reset it, since that can make the fault worse.
Oven Staying Cold?
Book a diagnosis and we will test the igniter, element and sensor. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
Related
Burner Not Igniting
When the cooktop side fails too.
Wall Oven Repair
Element, igniter and sensor work.
Range Repair
Oven and burner diagnostics.